• Apollo 70-900 Series Bronze Ball Valve, Two Piece, 3-Port Diverting, Lever, 3/4

Apollo 70-900 Series Bronze Ball Valve, Two Piece, 3-PORT Diverting, Lever, 3/4" Solder End

The Apollo 70-900 series bronze two-piece inline 3-port diverting ball valve has a lever handle and solder ends on all ends. The valve body is made of bronze for higher strength and corrosion resistance than brass. This valve has a zinc-plated steel lever handle with a vinyl sleeve for manual on/off control. Reinforced polytetrafluoroethylene (RPTFE) seats and stem packing reduce the risk of leakage. The valve is standard (or regular) port for reduced valve size and cost. It has solder ends for a strong and durable heat-joined bond using solder and a torch. The maximum pressure rating is 600 pounds per square inch (gauge) (psig) for cold working pressure (CWP), and the maximum temperature is 500 degrees Fahrenheit. This valve meets Manufacturers Standardization Society (MSS) SP-110 and WW-V-35C Type II standards for quality assurance.

Ball valves use a spherical disc to control the flow between pipes, tubes, or hoses. Flow is allowed when the hole that pierces the ball-shaped disc is in line with the inlet and outlet of the valve. Flow is blocked when the ball is horizontally swiveled 90 degrees, so that the hole of the ball is perpendicular to the opening of the valve. Ball valves can be referred to as full port or reduced port (also known as regular or standard port) depending on the inner diameter of the valve. A ball valve is full port if the hole of the ball is the same size as the inner diameter of the connecting pipeline (resulting in lower friction) and is reduced port if the hole of the valve is one pipe size smaller than the pipe, resulting in less flow through the valve than through the shaft of the pipe. Ball valves may have a handle or lever that aligns with the ball's position (open or closed) for manual operation. They are primarily used in air, gas, liquid, and steam applications.

Apollo Valves manufactures ball, mixing, and relief valves, actuators, water gauges, marine fittings, heating and plumbing products, and backflow prevention. The company, founded in 1928 and headquartered in Matthews, NC, meets international standard International Organization for Standardization (ISO)/IEC 17025:2005 and makes products that meet International Organization for Standardization (ISO) and American National Standards Institute (ANSI) standards.

Apollo 70-900 Series Bronze Ball Valve, Two Piece, 3-PORT Diverting, Lever, 3/4" Solder End

  • Bronze for higher strength and corrosion resistance than brass
  • Lever handle with vinyl sleeve for manual on/off control
  • Standard port for reduced valve size and cost
  • Maximum pressure rating of 600 psig for CWP; maximum temperature of 500 degrees Fahrenheit
  • Solder ends for a strong and durable heat-joined bond using solder and a torch

Apollo 70-900 Series Bronze Ball Valve, Two Piece, 3-PORT Diverting, Lever, 3/4" Solder End

Shipping Weight1.4 pounds

Write a review

Note: HTML is not translated!
    Bad           Good

Apollo 70-900 Series Bronze Ball Valve, Two Piece, 3-Port Diverting, Lever, 3/4" Solder End

  • from Apollo Valve
  • Product Code: FTSE25118
  • Condition: BRAND NEW
  •  In Stock.
  • $40.99   + 7.99 Shipping